Blog-on-Chips

Overview: LOC Devices and Fabrication of PDMS Microfluidic Chips

tarihinde Nazım Yılmaz tarafından gönderildi

Overview: LOC Devices and Fabrication of PDMS Microfluidic Chips
Microfluidics is at the microscopic scale and fluid dynamics is the science of flows. It needs to make several different liquids enter the system, then it needs to build channels to make them, therefore it can be built the whole circuit in the first place so the liquids interact. 

Devamını okuyun →

What is Microfluidic and Lab-on-a-chip?

tarihinde Nazım Yılmaz tarafından gönderildi

What is Microfluidic and Lab-on-a-chip?

What are microfluidics and lab-on-a-chip?  This is introductory writing to the field. Microfluidics and lab-on-a-chip is a very broad field with many researchers. Often the research is very application-specific and therefore there is no area to fit in this specific writing. What is microfluidics?  It is the field of engineering that copes with fluids so that it can be caused by liquids, plasma, or fluidized particles but typically it is going to be liquid and these fluids are geometrically constrained on the micro-scale. That means typically it is inside microchannels. The fluid is at least either in two dimensions or...

Devamını okuyun →

What is Laminar Flow in Microchannels & Reynolds Number?

tarihinde Serhat Sevli tarafından gönderildi

What is Laminar Flow in Microchannels & Reynolds Number?
Today, it was accepted that microchannels have characteristic dimensions with a hydraulic diameter below 1 mm in microtechnology.

Devamını okuyun →

Microfluidic Chips for Detection of Microorganisms

tarihinde Nazım Yılmaz tarafından gönderildi

Microfluidic Chips for Detection of Microorganisms
Microfluidic chip systems have become promising for detection of microorganisms with high sensitivity, accuracy, low cost and rapidity.

Devamını okuyun →

A Review of PDMS Microfluidic Chips and Fabrication Techniques

tarihinde Serhat Sevli tarafından gönderildi

A Review of PDMS Microfluidic Chips and Fabrication Techniques
Poly(dimethylsiloxane) (PDMS) has been the most frequently used material in microfluidic devices due to the cost and relative duration of fabrication as well as material properties.

Devamını okuyun →